24
Installation Instructions
STEP 18 ADJUST DECORATIVE PANELS- FLUSH INSTALLATION ONLY
The panel can be adjusted approximately 1/8” both left
and right, up and down, as well as outward from the
door to provide planar appearance with cabinets.
NOTICE: Misaligned panels from incorrect drilling or
incorrect cut dimensioning may result in less possible
adjustment as well as possible interferences with other
attached panels and/or hardware.
1. The gap between the outside edge of the decorative
panels and the cabinet opening should be 9/16”. Adjust
panel until specified gap is maintained.
2. Turn the set screw at the hinge side (top and bottom)
of the refrigerator clockwise to adjust the door panel
toward the edge of the door opening. Check the gap by
closing the door. Use this same process on the freezer
drawer.
3. Check that the door panel is in plane with the face of
the cabinets. The panel can be adjusted outward by
turning the set screw threaded into the tab of the door
bracket at the top and bottom of the door clockwise
until the face of the panel is in the same plane as the
cabinetry. Use this same process on the freezer drawer.
4. Check the flushness of the panel with the cabinetry.
If the grille is not flush, adjustments can be made by
loosening the screws in the slots on the hinge and
moving the panel in or out. Once all adjustments are
made, retighten screws and close the grille.
9/16”
9/16”
Door panel, drawer panel.
and grille panel should be
flush with the fronts of the
cabinets.
Turn set screw on
hinge side, top and
bottom, clockwise
to move toward the
door opening.
Turn set screws on tabs at
top and bottom of door to
move panel in or out to be
flush with cabinetry.
Use these screws
to adjust the grille
panel in or out -
both sides.
Содержание ZICS360NHLH
Страница 27: ...27 Notes ...
