Mono DELTA DEPOSITOR, Руководство по эксплуатации

Страница: 13 / 60

FG073
– DELTA CONT. RevA17 10-4-17
13

Edge Height
The depth, in millimetres, of the highest edge (leading or trailing) of the tray.
This will provide information to park the depositing nozzle at the correct height between the
completion of the depositing sequence on one tray and the start of the depositing
sequence on the next tray and, also, prior to the introduction of the first tray. For additional
safety it is worthwhile adding 10mm to the actual tray edge height to avoid any possibility
of collision between depositing nozzles and a tray that might be slightly buckled.
i.e. for actual edge height of 20mm
Entered value should be 20mm + 10mm = 30mm (See Fig. 3.1.1.1b).
IMPORTANT - No automatic tray edge height detector exists on the DELTA and this
programmed
height value is stored into the controller’s memory for the particular product in
question, hence, it is imperative that no tray with an edge height greater than the
programmed value is used, otherwise damage to the machine may result.

Rows per Tray
The number of repeated rows of deposited product required along the tray’s length.
NOTE - this value does not correspond to the number of products deposited across the
tray, i.e. the number of nozzles on the template in use. When the LH side key
corresponding to this option is pressed, in order to allow data entry, the maximum
allowable number of products per tray will be displayed in the on-screen prompt message.
This value is automatically calculated based on tray length value, rotary template nozzle
offset length (see 3.2.4) and individual product length.
Fig. 4
Fig. 5
Edge height illustration
Fig. 6