Moniteq Crypto Lock CC-8521BN, Инструкция по эксплуатации

Страница: 7 / 20

7
3. SUPPLIED EQUIPMENT
The Crypto-Lock consists of two main
units, the Keypad and the Control Panel.
The table below lists all of the items that comprise the Crypto-Lock along with a
brief description of each to aid in their
identification and use.
QTY ITEM PURPOSE
1 Control Panel Main processor and power supply
1 Keypad with 20 ft. cable PIN code entries and programming
functions
1 Threaded rod, #8 x 12
”
Keypad mounting, thru-wall
4. FUNCTIONS OF CONTROLS AND INDICATORS
4.1 KEYPAD
Normal Operating Mode:
Keys 1 through 0: Used to enter the PIN
code.
# Key: Sounds a horn in the Control Panel
and also activates a 24 Vdc output signal
for use with an external device.
* Key
– Not used
Green LED indicator:
Illuminates when the door is released
Flashes when any key is pressed
Programming Mode:
Keys 1 through 0: Used to enter
programming codes
* Key: Used as a delimiter for programming
codes and parameters.
# Key: Used to terminate the programming
mode.
Green LED indicator:
Programming mode: Flashes continuously
After a valid programming entry: Single
flash
After an invalid programming entry: Three
flashes
4.2. CONTROL PANEL
LED Indicators:
PENALTY
: Illuminates when an invalid PIN
has been entered on the keypad.
UNREG 24VDC : Indicates that the system
is AC powered and the rectifier is
functional.
REG 24VDC : Indicates that 24VDC is
available for powering the lock and other
external devices.
BAT : Indicates that system has no AC
power and is powered by the batteries.
LOW BAT : Indicates that the battery is
low.
LOCK : Indicated that the lock relay is
energized.
AUX ALARM : Indicates that the Auxiliary
Alarm output is active
Horn: See Table 6-1, Alarm Sequences
Fuses:
Chassis Mounted fuse holder, 2A Slo Blo,
0.25 x 1.5”
F6: 12 Vdc power, 2A, 5 x 20 mm
F7: 24Vdc power, 2A Slo Blo, 5 x 20 mm
F8: Battery power, 2A Slo Blo, 5 x 20 mm
F9: Lock power, 2A Slo Blo, 5 x 20 mm