Moniteq Crypto Lock CC-8521BN, Инструкция по эксплуатации

Страница: 13 / 20

13
7. OPERATION
To operate the Crypto-Lock, enter the valid
3, 4, 5, or 6 digit PIN code on the keypad.
When the valid PIN code is entered, the
green LED on the Keypad will illuminate
and the lock will release.
The Keypad has a built-in visitor
annunciator button. Pressing the # key
causes a horn to sound in the Control
Panel. If an external sounding device is
connected as shown in Figure 5-1 it will
also sound when this button is pressed.
If an incorrect PIN code is entered the
system will enter a penalty mode and will
not recognize any digits for a time period of
from 5 to 60 seconds. If five successive
invalid PINs are entered the penalty time is
set to 60 seconds until the valid PIN is
entered. After the penalty time has elapsed
the Panel will return to normal operation
and entering the valid PIN code on the
Keypad will release the door.
The internal Release Button on the Control
Panel can be used by an attendant to
release the lock from a location on the
secure side of the door. Similarly, if a
remote release button has been installed it
can also be used to release the door.
Alarms
Various alarms can be programmed to
activate different horn sequences and
activate 24Vdc output signals.
Internal Horn and Horn Output Signal
(T3-9)
Table 7-1 lists the horn sequences and
their meaning.
Table 7-1, Alarm Sequences
Alarm
Type
Alarm Sequences
(HORN and T3-9 Output) Silenced by:
Visitor Activated by # button on keypad
Invalid PIN - - - - - Five short
beeps After five short
beeps
Door
Propped
____ ____ ____ ____ ____ Long bursts Door closed or
time out set by
code *23*N*
Forced Door - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Short bursts Valid PIN or code
*24*0*
Low Battery - - - - Chirp every 15
seconds
Apply AC power
Aux. Alarm _ __ _ __ _ __ _ __ _ __ _ __ _ __ _ __ Short/long
bursts
Door closed or
lock released