SR5i Technical Manual
TSP095.doc Issue 1.0 – July 2004
©
Money Controls 2004. All rights reserved.
18.11 Teach and Run
™
Token “F”
Position F allows a token, which is not currently in one of the pre-programmed groups, to be
programmed on site.
To
Teach and Run
™
a token, ensure that the SR5i is powered up through the main parallel
connector.
Turn the rotary switch to position F.
Press and hold the program button, (situated underneath the rotary switch), the LED will
change from Green to Red, release the program button; the LED will flash Yellow and Red.
Note: If the LED stays Green then Teach and Run
™
Token “F” is not available.
Insert several of the coin type to be taught, typically 8 coins, until the LED flashes Green. If
the SR5i encounters a problem during Teach and Run
™
the LED will flash Red.
Press the program button, the LED will stop flashing.
The SR5i automatically selects the newly programmed token after Teach and Run
™
.
Turn the rotary switch to position C, to accept the newly programmed token, press the
program button, the LED will turn Red. Release the program button, the LED will return to
Green and the new token will be accepted.
If an error occurs during this procedure then the LED will change to flashing Red. Press the
program button, the LED will change to Green. The token that was previously programmed
will still accept.
To stop programming before the LED changes to flashing Green, press the reject lever, the
LED will change to flashing Red. Press the program button, the LED will change to Green.
The token that was previously programmed will still accept.
Note: NEVER leave the acceptor with the rotary switch in positions D, E or F.
18.12 Teach and Run
™
Coins
Teach and Run
TM
is only available in serial mode (via ccTalk) – allowing the programming of
all 16 coin positions.
IMPORTANT:
(
Teach and Run
TM
Token “F” is not available in serial mode).
