21
Monessen • Glow Getter Owner’s /Installation Manual • 4606-900 Rev. A • 8/17
6. Hold log #5 with the pointed end toward the right.
Place log #5 by positioning the pin locator hole on
the bottom of the log over the left pin behind the grate
and resting the left end of the log over the notch on
log #3. Note: Logs #4 & #5 must be seated and
locked into positon. The ember face of logs #4 and
#5 should be straight and approximately 3/8” behind
the grate bar. See Figure 5.6.
5
Figure 5.6 - Log #5 Placement
B. Log Placement (Moxie)
1.
Before installing logs, place rock wool in front of the
grate. Loosely apply nickel size pieces to allow the
gas to flow through for proper burn and not to be
obstructed. Failure to do so would cause a higher
level of CARBON MONOXIDE. See Figure 5.10.
7. Hold log #6 with the flat end toward the back. Place
log #6 by positioning the pin locator hole on the
bottom of the log over the pin on log #2 and set on
top of log #4. See Figure 5.7.
6
Figure 5.7 - Log #6 Placement
8. Hold log #7 with the pointed end to the left and the flat
end toward the bottom. Place log #7 by positioning
the two pin locator holes on the bottom of the log over
the pins on log #1 and #2. See Figure 5.8.
7
9. Hold Log #8 with the branched end away from you.
Place log #8 by positioning the pin locator hole on
the bottom of the log over the pin on log #1 and by
rotating the log counter clockwise to match the notch
on the log with the first tine on the grate. See Figure
5.9.
8
Figure 5.8 - Log #7 Placement
Figure 5.9 - Log #8 Placement
1
2. Hold log #1 with the pointed end to the left. Place log
#1 behind the grate by positioning the two pin locator
holes on the bottom of the log over the pins behind
the grate. Push the log down to make sure it rests flat
over the metal base. See Figure 5.11.
Figure 5.10 - Installing Rock Wool
Figure 5.11 - Log #1 Placement
3. Hold log #2 with the flat surface to the right. Place
log #2 to the right side of the burner assembly by
positioning the pin locator hole on the bottom of the
log over the pin on the right-hand side. See Figure
5.12.