Monessen • Glow Getter Owner’s /Installation Manual • 4606-900 Rev. A • 8/17
14
Figure 3.10 - Securing Heater to Floor of Fireplace/Fireox
Assembly Procedure
1. Attach the two brackets shipped with the engine
assembly to the engine base on the right and left hand
side using the two sheet metal screws shipped with the
brackets.
2. Center the burner assembly inside the fireplace or
firebox. Make certain that the front of the burner
assembly sits inside the front edge of the fireplace or
the firebox.
3. Anchor holes are located on the right and left sides of the
brackets attached to the engine base. After centering
the burner assembly correctly, mark the holes on the
fireplace or firebox floor. Drill two (2) 5/32” diameter holes
approximately 1 ¼” deep. Anchor the two anchoring
screws shipped with the unit using ¼” hex head chuck
and secure the burner assembly to the fireplace through
the holes drilled earlier.
You must secure the gas log heater to the fireplace
floor. If not, the entire unit may move when you
adjust the controls. Movement of unit may cause
shifting of the gas logs which leads to sooting and
improper burning. Grate movement could cause a
gas leak.
Special care is required if you are installing the unit
into a sunken fireplace. You must raise the fireplace
floor to allow access to gas log controls. This will
insure adequate air flow and guard against sooting.
Raise the fireplace floor using noncombustible
materials, as described in Placement in a Fireplace
with Restrictive Barrier on Page 7.
WARNING