Monessen Hearth AVFLST42NTSC, Инструкция по установке и эксплуатации

Страница: 21 / 40

20308636
21
AVFLST Vent Free Fireplace
TOUCH SCREEN REMOTE CONTROL OPERATION
NOTE: Due to the sensitive temperature monitoring
components in the transmitter, it is necessary to allow
the transmitter to stabilize to room temperature before
accurate room temperatures are displayed. If the
transmitter is activated from a severe cold condition,
allow 15 minutes for accurate temperature readings
to appear on the LCD display.
WARNING!!
Turn appliance OFF (at the Master Switch) if you
are away from your house for an extended period of
time. Never leave anything on top of the surface of
the transmitter.
n
Function Areas of the LCD Display
Figure 18 shows the display of the TSFSC LCD.
Information Bar
The information bar shows the room temperature, the
“sending signal” radio icon, the low battery indication icon,
the child-proof icon, and the flame icon. This area doesn’t
have touch buttons.
•
The room temperature will always be shown after
power-up. It displays the room temperature from 40
°F to 99 °F. “Lo” and “HI” will be displayed when the
room temperature is lower than 40°F or higher than
99°F, respectively.
•
The radio icon will be shown when the transmitter is
sending a signal.
•
The low battery indication icon will be shown when
the battery voltage is low.
•
The child-proof icon will be shown when the child-
proof mode is activated.
•
The flame icon indicates the current flame height –
Off, Low, Medium and High
Touch Area
The touch area contains all touch buttons to control the
transmitter. It consists of two categories: menus and ad -
justment arrows. The blue LED backlight lights up for 8
seconds when any of the touch buttons is pressed.
•
The menus include TIMER, THERMO, LIGHT and
AUX.
•
The adjustment arrows include ON/up and OFF/
down. Their default function is to adjust the flame
height. When a button from the menu is pressed,
the ON/up and OFF/down buttons will temporarily
become adjustment controls for the selected item.
When the adjustment is done, the ON/up and OFF/
down buttons go back to flame height controller
again.
Logo Bar
The Logo Bar contains the brand logo: Signature Com -
mand
®
System.
n
Initialization and Setting up
Installing Batteries:
Figure 19
The remote transmitter has two
battery compartments, one on
each end of the transmitter.
Al-
ways change all four (4) batter-
ies at the same time.
To install batteries,
1. Press down the battery door
tab and pull out to remove the
battery door.
2. Install the batteries as indicat -
ed inside the battery compartments.
3. Close the battery door by snapping in place.
4. When all
four
batteries are installed, the transmitter
will initialize for 5 seconds and then is ready for use.
5. The batteries should be replaced every 12 months or
when the low battery icon indicator is displayed.
Changing Temperature Unit
When batteries are installed in the transmitter,
1. All available icons on the LCD will be turned on then
be cleared.
2. The LCD will display temperature unit: °F. Use ON ∆
to toggle the units between °F and °C within the first 5
seconds.
3. The transmitter enters Manual Mode
4. The LCD displays room temperature with the chosen
unit.
FP2646
TSFSC display
Information
Bar
Touch
Area
Logo
Bar
Menus
Adjustment
Controls
Function Areas of the LCD Display
Figure 18.
FP2607
install battery
Battery
Door
Tabs
Figure 19.