Replacing the Battery
1. Be sure that the replacement battery is
plugged into the PCB firmly.
2. Carefully place the right half (1055-4241-
111) onto the left (1055-4242-111).
3. Align the display board [E], battery [F],
and main PCB [G] into the slots provide in
the case.
4.
Align the display and battery first, then
from the front of the unit, guide the PC
Board into the retaining slots with a
wooden stick. Ensure the trigger wires [H]
and DC Jack [I] are properly in place.
[F]
[E]
[G]
[H]
[I]
[J]
[K]
Nova-Strobe Battery Replacement 1/2022 v3.1
[D1]
[D2]
[D1]
Top half of the
Battery Holder
sits in the right
side case.
Note the position
of the cradle
guides
Helpful Tip:
Placing the left side of the case
on a roll of tape or other lift
will prevent the speed knob
from pushing the PCB out of
the retaining slots when
aligning all.
5. Fasten both halves using two 2
"
self tapping screws [D]
(1053-3328-001) through the body of the right half. Do
not over tighten screws.
6. Gently pry apart case halves at the base of the handle
and insert T-nut [J] (1053-0270-001) into slot in left
handle.
7. Slip knotted end of wrist strap [K] (3051-2000-015) over
left half handle standoff and through slot provided.
8. Carefully press case handles together, ensuring the
wrist strap fits into the notch provided and no wires are
pinched between the case halves.
9.
Reattach the reflector housing.
10. Do not over tighten screws [C], [D1], [D2].
