Molten Voltage™
Master Control MV-58
Owner’s Manual - p.8
© 2015 - MoltenVoltage.com - All Rights Reserved.
v 1.09
Active and Passive Program Select Modes (
version 1.08 and later
)
MV-58 version 1.08 and higher has two modes for selecting programs, Active and Passive.
In
Passive Mode
, pressing the Up or Down buttons selects a pending program, indicated by the flashing
program number. The program is not sent until the Start button is pressed.
Passive Mode is the default
, and the way that all earlier versions operate.
In
Active Mode
, each time the Up or Down button is pressed, the corresponding MIDI Program Change is
sent instantly. This is true whether MIDI Clock is being sent or not.
The current mode is indicated by the decimal point in the displayed program number. The decimal point
flashes while in Passive Mode, and stays lit all the time in Active Mode.
You can select which mode will be used on startup
by holding down the Down button while powering
on Master Control. The MIDI Channel number will be displayed first. Press the Start button twice, until
the display reads Pnd. or Act. Switch modes by pressing the Up button. Lock in your selection by
pressing the Down button.
Switch between the two modes during runtime by pressing both the Up and Down buttons at the same
time.
Version 1.08 always allows switching modes during runtime.
Version 1.09 allows you to turn this feature on and off by holding down the Down button while powering
on Master Control. The MIDI Channel number will be displayed first. Press the Start button until the
display reads rt.Y (real-time Yes) or rt.n (real-time No). Switch modes by pressing the Up button. Lock in
your selection by pressing the Down button. v 1.09 default is to have this feature off.
SIMI SysEx Compatibility (
version 1.08 and later
)
When selecting pending programs in Passive Mode, Master Control version 1.08 and later will send out
SysEx data allowing SIMI to flash the pending program name.
The default is for this feature to be active.
To turn this feature off, hold down the Down button while powering on Master Control. The MIDI Channel
number will be displayed first. Press the Start button until the display reads Sd.Y (send Yes) or Sd.n
(send No). Switch modes by pressing the Up button. Lock in your selection by pressing the Down button.
Factory Preset Values
Programs 1-64 are 120 bpm
Programs 65-128 are "oLd"
MIDI Channel 15
