Molten Voltage™
Master Control MV-58
Owner’s Manual - p.7
© 2015 - MoltenVoltage.com - All Rights Reserved.
v 1.09
Tempo information
If a Program has a fixed tempo associated with it, the far right decimal point (after the last
character) will be
off
. If a Program uses the “oLd” tempo from the previous Program, then the far right
decimal point will be
on
.
When the TAP Button is pressed (for less than 2.5 seconds), the current tempo will be displayed.
The tempo can then be changed by tapping again, pressing the UP or DOWN Buttons, or turning the
SELECT Knob.
Programming information
If the TAP Button is pressed and held for 2.5 seconds, the display will show the letter “P” to
indicate that upon release of the button, the selected Program will be stored.
If the DOWN Button is pressed while the TAP Button is being held, the decimal after the “P” will
turn on, indicating
that
program will use the “oLd” tempo from the previous Program, rather than the
current tempo.
MIDI Compatibility
The primary MIDI channel for the Molten Voltage system is MIDI Channel 15. All MIDI Program
Change messages are sent exclusively on that channel.
Molten Voltage devices all read MIDI messages on Channel 15 by default.
Set any other devices to receive MIDI Program Change messages on Channel 15.
Changing MIDI Channel
Although changing the MIDI Output Channel is not recommended because Molten Voltage devices
read MIDI messages primarily on Channel 15, it is possible to change the Master Control MIDI Output
Channel as follows:
1)
Hold down the DOWN Button as you power the unit on. The unit will display a lowercase “c”
with a period after it follow by the current MIDI Channel. (
e.g.
c.15
)
2)
Release the DOWN Button.
3)
Repeatedly press the UP Button to cycle through the 16 possible MIDI channels (the cycle
will start over at zero after Channel 16 is reached)
4)
Once the desired MIDI Channel is reached, press and release the DOWN Button again. The
unit will re-start with the new MIDI Channel stored in memory.
