Molnar Hoists
All Rounder
Servicing
21
tighten
lock
clamp
100
mm
16
Remove isolation lock out (ie: turn hoist ON)
17
Adjust twin springs:
Raise hoist and compress the twin
springs. Using a clamp and
15
mm spanner, tighten the
nuts until the springs are almost fully compressed.
Refit the lock nuts to the end of each cable thread,
ensuring you hold the upper nut in place as you tighten
the lower nut (so as to not change the position of the
springs).
18
Refit trigger bracket, washer and secure with circlip.
19
Readjust long cable ensure 25mm initial pre-stretch
20
Lubricate all cables
21
Re-lube posts and refit covers
Readjustment of long Wire Rope required
after six weeks of operation
15
Attach the long Wire Rope to
non-control-post carriage
>
Feed the threaded cable
end through bracket on
carriage. Note, the carriage
may need to be raised to
insert the cable end.
>
Insert spring and sleeve
over cable end. Insert the
bracket (with bracket arms
positioned against the
carriage) and secure cable
end with the cable nut.
Tighten the cable nut
approximately 30mm to
fully expose the cable hole.
>
Feed linkages through
inside of the bracket
(washer at top) and attach
to linkage holes. Insert split
pins to secure.
>
Fit roll pin through hole
in the Wire Rope end and
hammer, leaving a few
millimetres protruding.
Wire Rope & Pulley Re-Insertion
Wire Rope & Pulley Re-Insertion
spring
sleeve
bracket
linkages
roll pin
cable nut
