Moller Medical Liposat power, Инструкция по эксплуатации

Страница: 28 / 36

Liposat
®
power
Liposat
®
power configuration
Page 28 of 36
Cleaning and care
Cleaning and disinfection
No humidity must be allowed to enter into the device.
Before cleaning and disinfecting the device surfaces, disconnect the mains
plug. Use a lint-free, soft cloth for cleaning and disinfecting.
The device is cleaned with a wet cloth in the form of a "scour-wipe-disinfection". Dipping or
spraying the device may cause hazards.
Cleaning shall be carried out with a dampened cloth with mild soap solution or 70% solvent
isopropanol.
After cleaning disinfect the surfaces of Liposat ® power with a pH neutral approved
disinfectant on detergence-alcohol-basis with up to 70% alcohol (e.g. Propan-1-ol,
recommended disinfectant: Meliseptol
®
). During disinfection, do always follow the
instructions of the disinfectant manufacturer.
Ensure that the cleaning and disinfecting agents have evaporated before using the
Liposat ® power in an application.
Visual check: The sockets of all connections and cable plugs must be free of all dirt and
moisture.
Maintenance
Upon reach of the STC date you will be informed by the Liposat
®
power
device itself during the booting process.
Repairs, upgrades or changes of the Liposat
®
power may only be performed by Möller
Medical GmbH or a company specifically authorized by the manufacturer. In the latter case,
the work performed must be documented, signed and dated. Changes to the device by third
parties are not permitted. A technical safety check must be performed at least every 12
months. Use the
Liposat ® power only if the device is functionally and/or operationally safe.
If this is not the case, have it immediately serviced.