
Impel™ Backplane and Daughtercard Tooling
Doc. No: TM-622018899
Release Date: 02-21-14
UNCONTROLLED COPY
Page 9 of 25
Revision: A
Revision Date: 02-21-14
Figure 2-3
MOUNTING INSERT MODULE IN
A MOUNTING BLOCK
TYPICAL INSERTION
MODULES
TOOLING HOLDER
Figure 2-4
TYPICAL INSERTION
TOOL ASSEMBLY
M3 x 8mm LONG
SET SCREWS (3)
EVENLY SPACED
Figure 2-6
CONNECTOR ASSEMBLY
ON PC BOARD SUPPORT PALLET
SUPPORT PALLET
LOCATING PIN
LOCATING PIN
PC BOARD
CONNECTOR
ASSEMBLY
Figure 2-5
ALIGNING TERMINAL PINS TO HOLES
PC BOARD
SIGNAL MODULE
3. Tighten the M3 set screws against the modules with two (2) set screws evenly spaced on a 10mm wide insertion tool and
at least three (3) set screws evenly spaced on a 25mm wide insertion tool. Figure 2-4 shows a typical completed
assembly.
CAUTION:
Do not over tighten the setscrews; this could damage the insertion tool.
NOTE:
See Section 4 for details on selecting modules and Press-In tools combinations.
2.4 Operation
Backplane
Insertion Tooling
1.
Carefully pre-insert, by hand, the backplane signal module(s) into the printed circuit board hole pattern. Make sure the
connector(s) are oriented properly by confirming the location of the #1 circuit notch with respect to the printed circuit
board layout. See Figure 2-5.
2.
Place the pre-loaded board into the support pallet (Optional). See Figure 2-6.
3.
Locate the tooling assembly in the connector assembly, carefully checking alignment. The orientation keys on the tool must
engage with the groove on the connector housing. See Figure 2-7.
4.
Position the pre-loaded support pallet under the press ram.