8
Operating the Controls
(cont’d.)
Using Your Humidifier
Speed Button
This humidifier is equipped with a
3-speed fan control. Initially depressing
the speed button will display the current
speed setting. Each push of the speed
button advances the mode through the
settings of
(HIGH) F3, (MEDIUM) F2
and (LOW) F1.
The selected setting is displayed on the
digital readout. The higher the setting, the
faster water is evaporated and released
into the air.
F1 (LOW)
is the quietest
setting and is provided for conditions that
do not require a rapid evaporation rate.
Refill Display
For maximum run time both the bottle
and the base should be filled. When both
the bottle and the base are empty, the
display alternates the room humidity
reading and
“F” (FILL)
, informing
additional water is required.
Humidity Control
This button allows you to adjust the
humidity to suit your needs. This humidifier
will automatically cycle on and off as
required to maintain the selected setting.
The readout displays both actual
(ROOM)
and desired
(SET)
humidity percentage
(%) settings when humidity control button
is pressed. The
ROOM
readout has a
range of 20% to 95% RH. If the room
humidity level is equal to or less than 20%
RH the display will show a flashing 20.
The
SET
readout has a range of 25% to
65% RH and is adjusted in increments of
5%. Initially depressing the humidity
button will display the current humidity
setting. Each additional press of the
button increases the setting by 5%. A
SET
point of 65% RH operates the
humidifier continuously regardless of the
ROOM
reading. The humidistat that
senses the readings is located on the
power cord. Insure that it is free from
obstruction.
Humidity
Button
Speed Button
Refill Display
SP6599-1 MoistAIR 3/29/06 1:13 PM Page 8
