Modena RX 9503, Руководство пользователя

Страница: 21 / 28

English
18
Some things to note for the installation of suction hood recirculating system:
1. Grease filters Carbon filters and both should be used.
2. Position the filter to be precise.
3. The holes where the air out there on the cabinet front suction hood should not be closed.
Note: Carbon filters are installed in the rear of the grid and had to be replaced after three months.
Warning: Carbon filters cannot be wash or recycle. Maximum use of carbon filter is 120 hours of use
and must be replaced afterwards. Carbon filters should not be exposed to heat.
Connect the plug to the power outlet.
Turning on or turning off the cooker hood and cooker hood lights can be done by sliding or pressing a
motor speed regulator button and the lighting button as shown below.
Note:
The setting of the cooker hood motor speed is adjusted to the thickness of the smoke/ steam that
arises when cooking.
Motor speed button – LOW
Suitable for air circulation used in the kitchen or cooking conditions that do not cause a lot of smoke
or steam.
Motor speed button MEDIUM
Air circulation speed which is suitable for a cooking process that raises a medium volume of smoke
or fumes.
Motor speed button – HIGH
When the level of smoke or steam produced is high enough, then use a high-speed level for effective
air circulation.
It is recommended to activate the hood 5 minutes before cooking and let it active during the cooking
process, then let it continue to be active for 15 minutes after cooking is complete.
Always open the steam reservoir N *.
If your product is equipped with a valve that is activated electrically or mechanically, lock or key or
handle that is used as a light controller and valves.
Part 3 :
How to Use
–