.
You now have to move the stick to full throttle again if not, then
leave the stick in the zero position
.
until the LED goes out again
1
3. Connect battery
.
1
4. Now the LED lights up
.
.
1
7. Now the LED lights up again
1
2. Turn on the transmitter, move the throttle stick to full throttle
forward
.
.
Autosetup AS12-15RW
.
1
5. Move the throttle stick to the “zero” position and hold it there
.
The ESC must be programmed to the receiver or the RC system
before it is used for the first time.
.
1
6. Pull the throttle stick back to full reverse
1
1. Connect the ESC to the receiver
1
8. Move the throttle stick to the "zero" / "motor off" position
.
0
9. After successful programming, the ESC signals through
a motor beep that it saved the values
10. Would you like a limitation of 50% engine power on reverse
12. After three short beeps, the ESC is ready for operation
To reprogram, simply turn on the ESC while the stick on the remote is
in full throttle.
if you didn‘t you will hear on long “beep”
The saved values are always saved, even without a battery
connected, and are only overwritten when programming is carried out
again.
.
.
11. If you have selected the 50% limit, two long beeps will now sound,
.