Model Shipways Bluenose, Инструкция по эксплуатации

Страница: 23 / 44

Winch shaft, gear, sprocket, and winch heads:
This assembly fits on the jumbo jib
boom crutch bitts. Starboard winch
head, bearing, and sprocket are already
on the shaft. Slide the large winch gear,
bearing, and port winch head onto the
starboard side. Enlarge the holes if these
parts don’t fit. Glue the assembly to the
boom crutch bitts, then add the port
and starboard winch head pawls
(Figure 5-9).
Make the clutch lever from brass strip.
Clutch shaft: On the lower clutch shaft is
a bearing and pinion. The pinion mates
with the winch gear. The shaft goes to a
clutch under the clutch box cover.
However, the clutch isn’t included.
Simply place the shaft in the box and
glue it to a block. Add a clutch lever
made from brass strip (Figure 5-9).
Engine and clutch cover boxes: Make the
boxes from 1/64” or 1/32” stripwood.
Sprocket chain: A single, riveted roller
chain (like on a bicycle) connects the
counter shaft sprocket and winch shaft.
For the model, fake it using double
thread or fine brass wire.
14. Catheads & Anchors
Attach eyebolts to the Britannia cat-
heads, then make the fitting for the deck
or just drill a hole in it (Figure 5-10).
During a race, catheads were removed
and anchors stowed below as ballast.
Model Shipways’ Grand Banks’ anchors
have Britannia shanks, but make their
stocks from stripwood. The plans show
how to stow the anchors, and the type
and amount of cable requir ed.
15. Mooring Chocks & Bow
& Stern Chocks
Chocks are Britannia. Check the plans
for their locations.
16. Hawse Pipes
Epoxy the Britannia hawse pipe lips in
the predrilled holes at the bow.
23
Fig. 5-10 Detailing The Catheads
Drill Holes
& Insert
Brass Wire
Eyebolt in
Buffalo Rail
Simplified
Catheads
Casting
Make a Socket or Just
Drill Hole in Deck
Fig. 5-11 Making Eyebolts
Drill Rod
Brass Wire
Twist
Glue
Holds
Tightly
1
3
2
Fig. 5-12 Pintles & Gudgeons
Pintle, Brass Strip
Solder or Glue Pin
Pins- Solder or
Glue, Cut Off
Option - Omit Pins and
Glue Strips to Hull
Option - Omit Pins and
Solder Strips
Gudgeon