Mode com MC-420, Руководство пользователя

Страница: 20 / 96

www.modecom.eu
20
WIRELESS ROUTER ADSL
[Dynamic Route]
RIP (Routing Information Protocol): Select this option to specify the RIP version, including RIP1, RIP2-B and RIP2-M.
RIP2-B & RIP2-M are both sent in RIP-2 format, the difference is that RIP2-M using Multicast and RIP2-B using Broadcast
format. RIP Direction: Select this option to specify the RIP direction. None is for disabling the RIP function. Both means
the ADSL Router will periodically send routing information and accept routing information then incorporate into routing
table. IN only means the ADSL router will only accept but will not send RIP packet. OUT only means the ADSL router will
only sent but will not accept RIP packet.
[Multicast]
IGMP (Internet Group Multicast Protocol): It is a session-layer protocol used to establish membership in a multicast
group. The ADSL supports both IGMP version IGMP-v1 & IGMP-v2. Select None to disable it.
Your ISP should provide the above information. Note that you must enter the user name exactly as your ISP assigned it. If
the assigned name is in the form of user@domain where domain identifi es a service name, enter it exactly as given.
(4) Bridge Mode
The modem can be confi gured to act as a bridging device between your LAN and your ISP. Bridges are devices that enable
2 or more networks to communicate as if they are 2 segments of the same physical LAN. Please set the Connection type.
The following table describes the labels in this screen.
LABEL DESCRIPTION
Encapsulation Select your encapsulation type from the dropdown list.
5.2 LAN
There are the IP settings of the LAN Interface for the device. These settings may be referred to as Private settings. You
may change the LAN IP address if needed. The LAN IP address is provided to your internal network and cannot be
seen on the Internet.
5.2.1 Router Local IP
IP Address: Enter the IP address of your ADSL router in dotted decimal notation, for example, 192.168.1.1 (default set-
ting). IP Subnet Mask: Your ADSL router will automatically calculate the subnet mask based on the IP address that you
assign. Unless you are implementing sub netting, use the subnet mask computed by the ADSL router.