Zeus200
Installation manual
V 1.0.7 - 12/10/2020
Page 11 of 28
3.
Connect the external water pump to the exchanger of the Zeus200 generator using anti-
crushing spiral pipes not supplied and the fitting (3). Use the second fitting supplied (3) at the
outlet of the exchanger to connect a second pipe in order to allow the cooling water to flow
out of the hull through a sea discharge.
Note:
the seacock must be located in a point that always remains below the waterline even if sailing
upwind. If a new sea cock is to be installed, a dynamic version is recommended. The sum of the
lengths of the spiral pipes must not exceed 4 meters. To lock the pipes use 2 steel clamps for each
fitting as per regulations. To block the fittings use specific sealant. The sea discharge must be
positioned 5/10cm above the waterline in order to avoid any smallest noise
Installation notes:
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
