Mobile TV MTV 19 SAT, Руководство по эксплуатации

Страница: 12 / 68

English
- 10 -
Installing the Batteries to the Remote
1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable/Satellite
IMPORTANT : The TV set is designed to operate on 12
V DC. For this, an adaptor is used which gives 12 V
voltage. Connect this adaptor to a system that supplies
110-240V AC, 50/60Hz. After unpacking, allow the TV
set to reach the ambient room temperature before you
connect the set to the mains.
SPDIF
VGA
13V dc /18V dc
3
00mAMax.
12V
DC IN
Aerial or Cable
Satellite
DiSEqC
Switch
To POWER
INPUT DC 12 V
terminal
AC adapter
SPDIF
VGA
13V dc /18V dc
3
00mAMax.
12V
DC IN
Switching On/Off
To Switch the TV On
Connect the power cord to the 110-240V AC,50/60Hz.
Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the “ ” button,
CH ^/ v or a numeric button on
the remote control.
Press the control switch located on the left side of the
TV. The TV will then switch on.
To Switch the TV Off
Press the “ ” button on the remote control or press
and hold the control switch on the TV until the TV
shuts down, so the TV will switch to standby mode
(Depends on the model).
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also blink
when you switch on the TV from standby mode.
First Time Installation
NOTE: If you are going to perform FRANSAT
installation, insert the FRANSAT card (optional) into
the Conditional Access terminal of your TV before
switching on your TV.
When turned on for the first time, the “language
selection” menu appears. The message “ Welcome
please select your language!
” is displayed in all
language options listed alphabetically.
Press the “ ” or “ ” button to highlight the required
language, press OK button to select. “First Time
Installation” appears. Use “ ” or “ ” button to set the
required country, and press “ ” button to select Search
Type. Use “ ” or “ ” to set the desired search type.
Available search types are Digital and analog, digital
only and analog only. When set, press “ ” to select
Teletext Language. Use “ ” or “ ” button to set the
“Teletext Language” and select “Scan Encrypted” using
“ ” or “ ” button. You can set Scan Encrypted as
Yes if you want to scan coded stations.