English
- 9 -
Using a Conditional Access Module
IMPORTANT: Insert or remove the CI module only
when the TV is SWITCHED OFF.
In order to watch certain digital channels, a conditional
access module (CAM) can be necessary. This module
must be inserted in the CI slot of your TV.
1.
Obtain the Conditional Access Module (CAM) and the
viewing card by subscribing to a pay channel company,
then insert those to the TV using the following procedure.
2.
Insert the CAM and then the viewing card to the
slot that is located in the terminal cover at the rear
side of the TV.
3.
The CAM should be correctly inserted, it is
impossible to insert fully if reversed. The CAM or
the TV terminal may be damaged if the CAM is
forcefully inserted.
4.
Connect the TV to the mains supply, switch on
and then wait for few moments until the card is
activated.
5.
When no module is inserted, “
No Common
Interface module detected
” message appears
on the screen.
You can refer to the module instruction manual for details
of the settings.
CAM
module
Standby Notifications
If the TV does not receive any input signal (e.g. From
an aerial or HDMI source) for 5 minutes, the TV will
go into standby. When you next switch-on the TV, the
following message will be displayed:
When the Auto Tv Off timeout is reached, the following
message will be displayed on the screen. Select YES
to shut down the TV. Select NO to cancel. The TV
will switch off as well, if you do not make a selection
on this screen.
If the TV has been left on and not been operated for
4 hours, the TV will go into standby. When you next
switch-on, the following message will be displayed:
Содержание MTV 19 SAT
Страница 2: ......
Страница 68: ...50238672...
