Mobeye MS100BK, Руководство по установке

Страница: 7 / 23

5
2.4 CONNECT THE POWER SUPPLY
The Mobeye MS100BK is designed to run on batteries, or to use an external power supply
(9-32VDC). Using external power, the module is always in connection with the GSM
network. This gives following advantages: a longer battery lifetime, possibility to receive
power failure messages (using the batteries) and the possibility to perform remote actions,
such as arm/disarm, switch the outputs, ask status reports and to program it via SMS-
commands.
Connect the external power adapter (or any other regulated 9-32VDC
power supply) to the power input of the connector (press on the orange
pins for connecting the wires):
•
V+ (black lead with white stripe) to “+”
•
Ground (black lead) to “-“
If using the Mobeye mains adapter (Mobeye article 10027):
The black wire with the white line
is “+”, the other black wire is “-“.
Close the Mobeye MS100BK using the 4 screws.
2.5 PROGRAM THE PHONE NUMBERS
You need to program at least one phone number in the unit as alarm number.
•
Enter your 4 dig
it code (factory setting: “1111”)
•
Press “menu”
•
Enter “101”
•
Press “OK”
•
Enter the phone number (e.g. 0712345678 or 0044712345678)
•
Press “OK”
The light turns green and a confirmation melody is played. The Mobeye MS100BK is ready
to use.
2.6 CHECK THE SETTINGS
The settings can be sent to the programmed telephone number as SMS text message. In
this way you also check the correct working of the SIM card.
•
Enter your 4 digit code (factory setting: “1111”)
•
Press “menu”
•
Enter “10”
•
Press “OK”
Within ca. 30 seconds the programmed phone number (TEL1) will receive the list with
settings.
2.7 SWITCHING ON
The Mobeye MS100BK is switched on automatically after programming the first telephone
number. To switch on/off manually, please refer to 3.1.
+ -