Mobatime DTS 4020.timebridge, Монтаж и инструкция по эксплуатации

Страница: 60 / 94

© MOBATIME 60 / 94 801299.00
Starting up after an update can also take some minutes (<10 min), or it can result in an
additional restart, as the file systems have to be checked first .
To eliminate any mistakes during update procedure, the versions should be verified
after the update.
7.5 Updating / restore device configuration via USB
To update / restore configuration on the DTS 4020, the following steps are carried out

all file names are case-sensitive, all names with 4020:
1. Copy dtsdevice.conf to the USB stick
2. Plug the stick in the DTS 4020
3. The update procedure can be started on DTS 4020 by selecting the menu '3.
Maintenance'

’2. Update software (USB)’ and press ENTER.
The message "Update in progress" appears and at the same time, “Please wait!>“
is shown in the command line. The DTS 4020 is automatically restarted on
completion of the update.
The Telnet or SSH session has to be restarted.
4. As soon as the DTS 4020 is restarted, remove the USB stick.
Notice:
The update procedure (point 3) may take longer time depending on the
type and number of images (<5 min) and must not be interrupted under
any circumstances. In case of an interruption, the software on the DTS
4020 is destroyed and can only be repaired in the factory.
Notice:
Ensure USB port is configured as “on”.

See chapter 6.5.23 General settings
To eliminate any mistakes during the update procedure, the versions should be verified
after the update.