Mobatime 122031, Монтаж и инструкция по эксплуатации

Страница: 33 / 124

© MOBATIME 33 / 124 801214.10
4. Poll-interval for NTP Multicast in 2^ poll-values in seconds (range: 1 – 16).
E.g. poll-value = 2

interval: 2
2
= 4 sec., poll-value = 5

interval: 2
5
= 32 sec.
For redundant Multicast time servers see remark next page.
5. Packet time to Live (TTL) for NTP- and time-zone-Multicast-packets in hops.
(Number of Routers in a network to transfer the packets through; for simple network
without routing, enter value "1", for 1 Router enter "2").
6. Repeat time to send time zone table: 10 – 86400 sec.
7. Delay time between the sending of the individual time zone entries (one entry per
Multicast packet) of the table: 1 – 60 sec.
8. Configuration of individual time zone entries. Displays menu “TIME ZONE TABLE“.
Notice:
Changes of multicast address, poll interval and TLL lead to a restart of
the NTP server.
Notice:
For the operation of a multicast communication (NTP and Time Zone
Server) the configuration of a gateway is required (see chapter “6.5.22
Network”). The gateway can be set manually or by using DHCP.
If there’s no gateway available, it’s possiible to set the own IP as gateway.
Notice:
Redundant Multicast time server:
If two NTP servers in the same network should send NTP with the same
Multicast IP address (redundancy), then the first time server has to be
configured with a small
pollinterval (e.g. 2

4 sec.) and second time
server with a large pollinterval (min. 100 x larger, e.g. 9

512 seconds).
As long as the first time server is sending NTP Multicast packets, the
packets from second time server are ignored. This configuration is
needed, to reach a defined situation for the end devices (the DTS with the
more frequently NTP send rate gets higher priority for time reception).
Time zone table for the NTP slave clock line:
DTS 4160.Grandmaster Moser-Baer AG
====================================
TIME ZONE - TABLE
Zone01: -1 Unknown season Zone02: -1 Unknown season
Zone03: -1 Unknown season Zone04: -1 Unknown season
Zone05: -1 Unknown season Zone06: -1 Unknown season
Zone07: -1 Unknown season Zone08: -1 Unknown season
Zone09: -1 Unknown season Zone10: -1 Unknown season
Zone11: -1 Unknown season Zone12: -1 Unknown season
Zone13: -1 Unknown season Zone14: -1 Unknown season
Zone15: -1 Unknown season
Enter requested entry
Press enter for next part, 99 to leave>
Path: 2 Configuration

1 Outputs

5 NTP slave clocks / time zone server

8 Configure
time zone table
Display of all time zone entries (15) of time zone servers for NTP slave clock lines.
Choose a zone number to change selected zone.
Time zone selection

see chapter “6.5.30 Time zone selection“.
Exit page with 99. Save changes with 98 in upper menu page.