INSTALLATION
Note - If this luminaire is being used in conjunction with an external PIR or sensor, please
confirm with the manufacturer of the sensors that they are compatible with LED luminaires.
• Provide power to the required point of installation
• Remove the front plate by placing a medium size flat-head screwdriver in the notch on
the side and lever off gently (see Fig. 1)
Fig. 1
INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following product
s
:
NH023AW / NH023B / NH025AW
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse, or circuit breaker
•
Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
•
This product is for indoor use only
•
This product is Class I and must be earthed
•
This product is IP20 rated
INSTALLATION
Note -
If this luminaire is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED luminaires.
•
Provide power to the required point of installation
•
Remove the front plate by placing a medium size flat-head screwdriver in the notch on the side and
lever off gently (see Fig. 1)
Fig. 1
•
Connect the luminaire to the mains supply ensuring the correct polarity is observed: L
–
Live (brown),
E
–
Earth (green/yellow), N
–
Neutral (blue)
•
All earth connections must be made and maintained. Use green/yellow sleeving on earth conductors
that are not insulated
•
Check all electrical connections are secure with no loose strands of cable
•
Fit the unit into a suitable wall box taking care not to compress, damage, or trap any cables, and
secure with the screws provided
•
Clip the front plate onto the main assembly ensuring the screwdriver notch is at the side
•
Switch on and check for correct operation
