MKS HPS 947 Series, Руководство по эксплуатации и обслуживанию, Страница: 19 / 40

13
HPS
®
Products Series 947 CEP System
1
5
6
9
Pin numbers
Any length up to 500 feet
TUBE
Female, 9-pin d-sub connector
24 AWG, 6 conductor
(3 twisted pairs)
Connect drain wire
to metal hood at
both ends
Drain wire
Mount 4 screwlocks in
connector hood assemblies for
strain relief
Customizing the sensor cable
CONTROLLER
Male, 9-pin D-sub connector
1
5
6
9
1,6
5,9
3
4
8
7
2
1,6
5,9
3
4
8
7
Adhesive backed rubber feet for bench top use are provided with the
mounting kit. Remove the adhesive backing from each foot and apply one to
each corner of the aluminum bottom surface.
Connecting the Sensor to the Controller
A sensor cable with 9-pin D-sub connectors (see Accessories, p.26) is
required for operation but is purchased separately from the CEP System.
When exerting excessive stress on the cable, use separate strain relief to
prevent damage to the Sensor or Controller. Cables are available in standard
lengths of 10, 25, 50, and 100 feet and in custom lengths up to 500 feet.
Connect the cable to the rear of the Controller at the Gauge port. Tighten the
connector jackscrews into the mating screw locks to ensure proper electrical
connection and to prevent stress on the connectors.
Turn off the Controller before connecting or disconnecting the
cable from the Sensor or Controller.