14
ASSEMBLY
Follow the assembly instructions to prepare your MK-101 for operation.
Cutting Head Installation:
NOTE: If the cutting head is installed, go to the next step.
UNPACKING, TRANSPORT, UNIVERSAL STAND AND ASSEMBLY
(A)
Align Cutting Head rear Pivot
Hole to the Post Pivot Shaft
and slide onto shaft.
(B)
Ensure Cutting Head Stop is in
upward position.
(C)
Install the Cutting Head onto the
Post Pivot Shaft and install the
Adjusting Knob.
For maximum cutting length,
the Cutting Head should be in
the front pivot hole and the Post
should be in the rear post
retaining hole.
NOTE:
For small tiles (6" tile or smaller) the Cutting Head should be
in the rear pivot hole and the Post should be in the forward post re-
taining hole. For large tiles and maximum cutting length, the Cutting
Head should be in the front pivot hole and the Post should be in the
rear post retaining hole.
NOTE: Move Cutting Head Stop in upward position when using rear
pivot hole and in the down position when using front pivot hole,
refer to page 24.
Post
