MK-100
Revision 1/01, Effective Date January 23, 2001
Page 23
SETUP, ADJUSTMENT and OPERATION
6. Adjusting the Post for Maximum Cutting Length:
The Cutting Head and Post are heavy! Care must be used when changing the position of the
Cutting Head.
Hold the Post when removing the Post Support Plate.
(A)
Ensure the ON/OFF Switch
is in the OFF position
Off
Position
ON/OFF
Switch
(B)
Unplug the GFCI from the
power source
(D)
Remove the Cutting Head (See
Adjusting the Cutting Head
(C)
Remove Water Basin
(E)
Loosen the Post Support Plate
and retaining bolts
(F)
Remove the Post Support Plate
and retaining bolts
(G)
Relocate the Post to the rear
Post retaining holes
(H)
Install and tighten the Post
Support Plate and retaining bolts
(I)
Install the Water Basin
(J)
Install the Cutting Head (See
Adjusting the Cutting Head
(K)
Plug the GFCI into the
power source
Post Support
Plate
Slide Water Basin
out front of Saw
Unplug
Cutting
Head
Turn counter-
clockwise to loosen
7/16-inch
Wrench
Post
Rear
Holes
Turn Clockwise
to tighten
9/16-inch
Wrench
Slide Water Basin
in back of Saw
Cutting
Head
GFCI Plugged
Into Power
Source
