06
07
BATTERY CLIP MODULE LED LIGHTS
USING THE AIR INFLATOR & CHANGING THE UNIT OF MEASURE
USING THE AIR INFLATOR
1. Screw the hose into the threaded hole on the side of the unit.
2. Choose the adapter that is right for the item you need to inflate. Attach it to the end of the hose and close the
valve locking lever.
3. Press and hold the power button for 3 seconds to turn the unit on.
4. Use the mode button to choose the type of device you will add air to (car, motorbike, bicycle, ball).
5. The unit will default to PSI (pounds per square inch), if your country uses another unit of measure go to
“Changing the unit of measure” section.
6. Use the up or down arrow keys to set the pressure you need.
7. Quick press the power button to start the pump. It will automatically stop when the desired pressure is reached.
Note:
if you wish to increase the pressure once the pump has automatically stopped, you will need to remove
the hose from the tire, ball, etc., reconnect it, and set the new desired pressure value.
8. When inflating items other than a vehicle tire it is best to check the pressure by hand as it inflates. Stop the
pump when you feel the pressure is right, this will prevent accidental over inflation.
CHANGING THE UNIT OF MEASURE
• Press the Unit change/Light button to change between PSI, BAR, KPA, Kg/cm2.
• When the unit of measure is chosen go back to the section “Using the air inflator”, step 5.
BATTERY CLIP MODULE LED LIGHTS
Blue LED is on, the module is getting power.
Green LED is on., the clamps are connected to
the vehicle battery.
Solid red LED + alarm when connected to
the vehicle battery means the clamps are not
connected correctly. Check the connections.
Make sure the red is on the positive terminal
and the black is on the negative terminal.
Solid red LED + alarm when not connected to
a vehicle means that the clamp module has
been damaged and will no longer work. Contact [email protected] for assistance.
