Mitsubishi TDP-459, Руководство пользователя

Страница: 8 / 86

Chapter 1 Safety Precautions
-2-
1.1 Cautions for working environment and installation
Pay attention to the following to use the THERMAL DIGIPLATER safely:
Do not install the Thermal Digiplater in an area with an extremely low or high
temperature. Do not install it, for example, in an area of a ski site or skating rink with
a low ambient temperature or in an outdoor area where it will be exposed to direct
sunlight and heat.
Do not put a vessel containing water, such as a vase, plant pot, cup, or any metallic
article on this Thermal Digiplater. If water is spilt or a metallic piece enters the
Thermal Digiplater, a fire or electric shock can occur.
Do not cover the vent holes of the Thermal Digiplater. Doing so will not allow the
heat to escape from the Thermal Digiplater, thereby causing a fire.
Do not insert or drop a metallic or flammable article inside through any vent hole.
Doing so can cause a fire or electric shock.
Provide an electric oulet at an accessible place near this product.
Do not use the Thermal Digiplater in an environment with volatile substances, such
as alcohol and thinner, or cumbustible gases.
Make sure that children do not touch the Thermal Digiplater and cables. Failure to
do so can result in injury or electric shock.
Do not install the Thermal Digiplater in damp, dusty or sandy places, such as a
bathing place, a bathroom, near a hot spring, on a road or by the side of a pool.
Doing so can cause a fire, electric shock or failure.
Do not install the Thermal Digiplater on a shaky stand, inclined floor or any other
unstable place. If so, it can fall or turn over and cause personal injury.