Mitsubishi TDP-459, Руководство пользователя

Страница: 47 / 86

Chapter 3 Use of Operation Panel
-41-
3.3.11 Adjusting the plate length in simple
This mode is used when plate length is adjusted in simple. Adjust using this function if you find
incorrect image size.
Print Length : Adjust image length (
①
)
Top Offset : Adjust the length that is from the plate edge to the print end (
②
)
Sensor Offset: Adjust the length that is from the print start to the plate edge (
③
)
Print test data
1.
Print a data with register marks.
[Useful tip]
Write down the print direction into a plate so that you correctly measure all size
①～③
. You wouldn't be able to adjust correctly if you make an error in a print
direction.
2.
Measure all items
①～③
correctly.
3.
Calculate the adjustment value using the
following formula.
The Adjust value = “The target value” – “the measured value”
・
The target value is 420mm if you use A3 image with register marks.
・
The adjust value should be “-1mm” if the measured value is “421mm”.
②
Print area
①
③
Print start side
P
rin
t d
ire
c
tio
n