Mitsubishi PAJERO IV, Руководство по обслуживанию

Страница: 13 / 72

BODY
PRE-DELIVERY INSPECTION
1-7
REMOVAL PROCEDURE
Wrapping work
AC306352
Disposal of removed film: Burning is appropriate
Water washing
Peel off slowly from corners keeping parallel to the body. When
the body temperature is high, lower it to 50ºC or less by
sprinkling water so that adhesive may not remain on the body.
Wrap film removal
Wipe-off by kerosene or white gasoline, etc.
If it is considerably visible, use polishing compound.
Cleaning of border
AB
No. Process Operation Content
1 Continuous peeling of film The film is peeled off.
2 Water rinse Sand and dust are removed from the vehicle body and it
is dried thoroughly.
3 Parts where the film is to be reapplied are
checked. There should be no leftover adhesive, swelling or
discoloration of the paint film, or other defects.
4 Treatment of parts where film is to be
reapplied. Treat the defects on the parts where film is to be
reapplied. If a solvent is used to remove leftover
adhesive, wipe off the solvent thoroughly.
5 Reapplication
1. Basically, the parts where the film is to be applied
should be the same as the film that is to be applied.
2. Apply the film from the lower portion of the body,
working upward progressively. Apply pressure using
a plastic squeegee or similar tool.
3. As necessary, cut the film at the various parts such as
windshield washer nozzles, hood and trunk lid.
CAUTION
•
Apply the film with the body at a temperature of 10
−
40
°
C. (Workability is good in this temperature
range.)
•
If the outside surface of the film (the side with no adhesive) is brought into direct contact with the
paint film and left in that state, it may result in loss of paint gloss, so make sure the film does not
get folded under or otherwise make contact with the paint film.
•
Air bubbles and wrinkles do not have a particularly bad influence on the pain film, but every effort
should be made to prevent air bubbles from being trapped under the film by applying pressure
from the centre of the film outward toward the edges during application.
•
To prevent intrusion of rainwater, be sure to press down the overlapping portions and cut ends of
the film securely.