7
4. Caution on Handling
(1) The module case and the terminal block are made of resin.
Do not drop the module or subject it to shock.
(2) Do not remove the printed circuit board from the module case.
This could cause failure.
(3) During wiring, take all possible measures to prevent wire scraps or
foreign matter from entering the module.
If anything enters the module, remove it completely.
(4) Tighten the module mounting screws and the terminal screws to the
torques specified in the following table:
Screw
Tightening torque range (N•cm)
Module installation screw (M4 screw)
78 to 118
Terminal block terminal screw (M3.5 screw)
59 to 88
Terminal block mounting screw (M4 screw)
78 to 118
