Mitsubishi MOTORS PAJERO OBKE10E1, Руководство пользователя

Страница: 114 / 394

l When the headlamps are turned off by the au-
tomatic on/off control with the ignition
switch in the “ON” position, the front fog
lamps (if so equipped) and rear fog lamp also
go off. When the headlamps are subsequent-
ly turned back on by the automatic on/off con-
trol, the front fog lamps also come on but the
rear fog lamp stays off. If you wish to turn
the rear fog lamp back on, operate the switch
again.
l Do not cover the sensor (A) for the automat-
ic on/off control by affixing a sticker or label
to the windscreen.
l If the lamps do not turn on or off with the
switch in the “AUTO” position, manually op-
erate the switch and we recommend you to
have your vehicle checked.
Daytime running lamp*
When the ignition switch is in the “ON” position
and the lamp switch is set to the “OFF” position,
the low beam of the headlamps, tail lamps, etc.,
will illuminate.
Lamps (headlamps, fog lamps, etc.) au-
to-cutout function
E00532700178
l If the ignition key is turned to “LOCK” or
“ACC” position or removed from the igni-
tion switch, and without opening the driver’s
door for 3 minutes while the lamp switch in
the “
” position, the lamps will turn off au-
tomatically.
l If the ignition key is turned to “LOCK” or
“ACC” position or removed from the igni-
tion switch and the driver’s door is opened
within 3 minutes while the lamp switch in
the “
” position, a buzzer will sound to
warn the driver that the lamps have not been
turned off, and these lamps will automatical-
ly turn off.
NOTE
l The lamp auto-cutout will not function when
the lamp switch is in the “
” position.
l When the ignition key has been turned to ei-
ther the “LOCK” or “ACC” position or re-
moved from the ignition switch with the
lamp switch in the “
” position, and the
lamp switch is returned to the “OFF” within
approximately 3 minutes, the auto-cutout
function will not be activated.
When you want to keep the lamps on
l Turn the lamp switch in the “OFF” position
while the ignition key is in the “LOCK” or
“ACC” position.
l Turn on the lamps with the switch in the
“
” or “ ” position again, then the
lamps will remain on.
l Remove the ignition key.
NOTE
l For further information, we recommend you
to consult MITSUBISHI MOTORS Author-
ized Service Point.
Lamp monitor buzzer
E00506100256
If the driver’s door is opened when the ignition key
is in the “LOCK” or “ACC” position or removed
from the ignition switch while the lamps are on, a
buzzer will sound to remind the driver to turn off
the lamps.
When the lamp auto-cutout function acts, the buz-
zer will stop automatically.
Dipper (High/Low beam change)
E00506200055
When the lamp switch is in the “ ” position, the
beam changes from high to low (or low to high)
each time the lever is pulled fully (1). While the high-
beam is on, the high-beam indiction lamp in the in-
strument cluster will also illuminate.
Instruments and controls
3-32
3