Mitsubishi Heavy Industries eco touch RC-EXC3A, Быстрая справка

Страница: 36 / 50

−35− −34−
3
When you tap the ▼ button, the suction grille will lower down to the descending length that was set and stops automatically.
To stop the descending motion of the suction grille at any point, tap the ▲ button.
To retract the suction grille, tap the ▲ button. The suction grill will move up, retract, and stop automatically.
To stop the ascending motion of the suction grille at any point, tap the ▼ button.
To set the descending length of the suction grille, tap the Length button ( ☞ 4 ).
Grille Up and Down
Back
Select the item.
Length Dust sign reset
* Grille can be stopped by pushing ▲▼
button opposite to moving direction.
Up
Down
4
Set the descending length of the suction grille.
The descending length can be set in units of 0.1 m using the
▲ ▼
buttons.
Descending length setting range: 0.1 to 4.0 m.
5
After you set the descending length, tap the Set button.
Note
・ When the suction grille is in descending motion, and you operate the unit from another R/C set as main/sub or from an option such as the central console, the unit will start operation (R/C display will
remain the same).
・ During heating operation, selecting Grille Up and Down may cause the IU fan to continue rotating for approximately 40 seconds.
Length
Back
Set descending length with ▲▼ button
Set
・ When the R/C is set as the sub R/C, IU unit selection cannot be made. All units will perform the up and down operation simultaneously.
・ When the suction grille comes to a stop at its prescribed position, the two wires may sag approximately 8 cm (max), and the suction grille may tilt, but this will be corrected automatically when the grille
retracts.
・ A loud sound may be heard due to this correction motion at the retraction position, but this does not indicate a failure of the unit.
・ When wire sag is detected due to the grille running over an obstacle, etc. the grille may not perform the up and down operation to avoid wires to get tangled. Remove the obstacle, tension the wires,
and press the
▲ ▼
buttons again.
Advice
PJZ012A172_EN.indd 34 2018/05/09 15:04:23