54
4. FAN operation (Only SL-1, 1.6, 2AR)
<How to operate>
1
Press POWER ON / OFF button.
2
Press MODE SELECT button to set operation mode to FAN.
NOTE : Temperature can not be set in FAN operation.
(1) Indoor fan control
The indoor fan speed LOW / MED./ HIGH depends on the remote controller setting.
6. TIMER operation
<Timer function>
It is convenient to set the timer when you go to bed, when you get home, when you
get up, etc.
1
Select the timer mode by pressing the button during operation
• Each time this button is pressed, the the timer mode is changed in sequence:
(OFF TIMER) (ON TIMER) TIMER RELEASE
2
Set the time of the timer using the button.
• Each time this button is pressed, the set time increases by 1 hour to 12 hours.
To release the timer:
• Press the button unit (OFF TIMER) and (ON TIMER) are not
displayed.
Note:
The OFF TIMER and the ON TIMER cannot be set at the time.
ON/OFF
RESET
TOO
WARM
TOO
COOL
MODE
COOL
DRY
FAN
FAN
VANE
SELECT
TIME
ON/OFF
RESET
TOO
WARM
TOO
COOL
MODE
AUTO COOL
DRY
HEAT
FAN
VANE
SELECT
1
2
TIME
h
ON/OFF
RESET
TOO
WARM
TOO
COOL
MODE
COOL
DRY
FAN
FAN
VANE
SELECT
TIME
h
1
2
TIME
SELECT
SELECT
5. AUTO MODE operation (Only SLH-1, 1.6, 2AR)
ON/OFF
RESET
TOO
WARM
TOO
COOL
MODE
AUTO COOL
DRY
HEAT
FAN
VANE
SELECT
TIME
<How to operate>
1
Press POWER ON / OFF button.
2
Press MODE SELECT button to set operation mode to AUTO.
3
Press SET TEMPERATURE button to set the desired temperature.
NOTE: The set temperature changes 1°C when the
▲
or
▼
button is
press one time AUTO MODE 19 to 28°C.
●
“AUTO” works to change by itself the operation mode either to cooling or heating
according to the room temperature.
(1) lnitial mode
1
When AUTO operation starts after unit OFF.
●
If the room temperature is higher than the set temperature, operation starts in COOL mode.
●
If the room temperature is equal to or lower than the set temperature, operation starts HEAT mode.
2
When AUTO operation starts after COOL or HEAT operation, the previous mode continues.
(2) Mode change
1
HEAT mode changes to COOL mode when 15 minutes have passed since the room temperature became 2 degrees above
the set temperature.
2
COOL mode changes to HEAT mode when 15 minutes have passed since the room temperature became 2 degrees below
the set temperature.
SLH-1AR
SLH-1.6AR
SLH-2AR
SL-1AR
SL-1.6AR
SL-2AR
SLH-1AR
SLH-1.6AR
SLH-2AR
SL-1AR
SL-1.6AR
SL-2AR
OC280-B-2.qxp 03.5.23 2:55 PM Page 54
Содержание SL Series
Страница 73: ...OC280 B 3 qxp 03 5 23 1 07 PM Page 73 ...