Mitsubishi Electric PEV-P200YM-A, Руководство по эксплуатации

Страница: 19 / 47

19
7. Other Functions
3) Select "OK" with the
F4
button.
F1 F2 F3 F4
Filter information
Filter information
OK Cancel
Reset filter sign?
Filter sign reset
Main menu:
A confirmation screen will appear.
F1 F2 F3 F4
Filter information
Filter information
OK Cancel
Reset filter sign?
Filter sign reset
Main menu:
Navigating through the screens
• To go back to the Main menu ............... MENU button
• To return to the previous screen ...........
RETURN
button
When the is displayed on the Main display in the Full mode, the system
is centrally controlled and the filter sign cannot be reset.
Cool
Room
Auto Set temp.
Mode Temp. Fan
Fri
If two or more indoor units are connected, filter cleaning timing for each
unit may be different, depending on the filter type.
The icon will appear when the filter on the main unit is due for
cleaning.
When the filter sign is reset, the cumulative operation time of all units
will be reset.
The icon is scheduled to appear after a certain duration of operation,
based on the premise that the indoor units are installed in a space with
ordinary air quality. Depending on the air quality, the filter may require
more frequent cleaning.
The cumulative time at which filter needs cleaning depends on the
model.
8. Function Selection
8.1. Function setting
<Function description>
Make the indoor units' function settings from the remote controller as
necessary.
• Refer to the indoor unit Installation Manual for information about the
factory settings of indoor units, function setting numbers, and setting
values.
• When changing the indoor units' function settings, record all the
changes made to keep track of the settings.
Button operation
1) Select Service on the Main menu, and press the
SELECT
button.
F1 F2 F3 F4
Main Main menu
Maintenance
Initial setting
Service
Main display:
Cursor Page
2) Select Function Setting on the Service Menu screen, and press the
SELECT
button.
F1 F2 F3 F4
Service menu
Maintenance password
Remote controller check
Function setting
Main display:
Cursor
3) The Function Setting screen will appear.
Press the F1 or F2 button to move the cursor to one of the
following: M-NET address, function setting number, or setting value.
Then, press the
F3
or
F4
button to change the settings to the
desired settings.
Once the settings have been completed, press the
SELECT
button.
A screen will appear that indicates that the settings information is
being sent.
F1 F2 F3 F4
Set / Conf
Sending data
Cursor
Select:
M-NET address
Function No.
Data
Function
3
32
2
3
32
2
M-NET address
Function No.
Data
Function setting
Function setting
Address
To check the current settings of a given unit, enter the setting for
its M-NET address and function setting number, select Conf for the
Function, and press the
SELECT button.
A screen will appear that indicates that the settings are being searched
for. When the search is done, the current settings will appear.