Mitsubishi Electric PAR-FL31MA, Инструкция по эксплуатации

Страница: 6 / 16

7
GB
OPEN
1
2
4
3
ON
• Use two 24A size alkaline
batteries. Make sure you align
the battery polarities correctly.
• Remove the batteries if you do
not expect to use the controller
for a long time.
After refilling batteries,
press the reset button.
Reset
Adhesive double
coated tape is
provided on the
back.
Plate
Figure 2
4. Before Operation
4-1. Setting the DIP-Switch
It is necessary to set the DIP switches before using this remote control unit.
∗
The remote control unit will not operate properly unless the DIP switch settings are correct.
∗
Customers should not perform the settings themselves, but rather should request that the settings
been made during installation by qualified personnel.
DIP Switch Settings
1
Check the settings (fan speed, louver, etc.) of the indoor unit and the outdoor unit to which it is
connected.
2
Adjust the DIP switches on the back of the remote control unit as necessary.
(Refer to Table 1 and Figure 1)
Table 1
SW OFF ON Description
1
AUTO mode is not AUTO mode is
supported supported
–
2
SWING (vane) SWING (vane)
is not supported is supported
Set to OFF on units which unsupported adjustable vane.
3 4-stage fan speed 2-stage fan speed Set to OFF on units which unsupported fan speed control.
4 COOL/HEAT unit COOL only unit Set to OFF when SW1 is set to ON.
Factory settings are all OFF.
Figure 1
3
After making the DIP switch settings, remove the battery cover and insert two batteries.
4
Using a ball point pen or similarly pointed object, push the reset button and replace the battery
cover.
5
Verify that the remote control unit operates properly. If
it does not, check the indoor and outdoor units, then
redo the DIP switch settings.
6
After verifying that the remote control unit operates
properly, attach the protective plate over the dip switch.
(Refer to Figure 2.)
7
The DIP switch setting is now set up properly.
1
2
4
3
ON
OPEN
1
2
4
3
ON
• Use two 24A size alkaline
batteries. Make sure you align
the battery polarities correctly.
• Remove the batteries if you do
not expect to use the controller
for a long time.
Factory setting
(All OFF)
RESET button
Battery cover
Rear view of original
remote controller