Mitsubishi Electric MSZ-AP60VG, Руководство по установке

Страница: 7 / 8

6-1. REMOVING AND INSTALLING THE PANEL ASSEMBLY 6-3. PUMPING DOWN
When relocating or disposing of the air conditioner, pump down the system following the
#
1) Connect the gauge manifold valve to the service port of the stop valve on the gas pipe
#
""} #
3) Close the stop valve on the gas pipe side of the outdoor unit almost completely so that it
# '~x™{š'<#L‹
8UHMMR
To start the emergency operation in COOL mode, disconnect the power supply plug and/
##<Q#: $ L
<$ zMU%!HMMR
# #@'
5) Fully close the stop valve on the gas pipe side of the outdoor unit when the pressure
'':'~x™{š':'<#L‹
.UHMMR
x zMU% " Rz= ##N# -
#
6. RELOCATION AND MAINTENANCE
When pumping down the refrigerant, stop the compressor before disconnecting
the refrigerant pipes. The compressor may burst if air etc. get into it.
WARNING
5. CONNECTION SETUP OF THE Wi-Fi INTERFACE (VGK type only)
! }%T;#
N#Uz!|x|;H–NzzNzVHz{|;=zMxzNQ!;V{;VU!N|H!;MVU"#
6-2. REMOVING THE INDOOR UNIT
Remove the bottom of the indoor unit from the installation
When releasing the corner part, release both left and right
bottom corner part of indoor unit and pull it downward and
#
If the above method cannot be used
N"!$ } #
# #!-
# <
Removal procedure
N"#
N".
@! #
Remove them in the following order: panel and
!"$#
To remove the top panel, pull out the right and
#
Installation procedure
1) Install the panel assembly following the removal
"
S
arrows in order to attach the assembly completely
Push
Lower
Square hole
1
1
2
2
2
2
3
3
2
2