Mitsubishi Electric MR-WX60F, Руководство по эксплуатации

Страница: 8 / 88

Before Use
Warning
Turn on the power
of the refrigerator
as soon as possible.
Dedicated
outlet that meets
the specified rating.
Install the refrigerator in a location which meets the following
requirements.
●
A place with good ventilation and not exposed to direct
sunlight or hot air
This is to ensure good cooling performance and reduce power costs.
●
A place with low humidity
This is to prevent rusting.
●
A strong and level place
This is to prevent vibration, noise, and ajar or tilting doors.
This is also to prevent deformation or discoloration of the floor materials
due to weight or heat.
* If there is concern of deformation or discoloration of the carpet, tatami
mat, wooden flooring, or PVC or other floor material, lay a sturdy plate
under the refrigerator.
●
A place away from other devices
This is to prevent noise or picture interference with devices such as
televisions.
●
There should be space of 0.5 cm or more on the left and right
of the refrigerator, and 5 cm or more from the ceiling.
This is to ensure space for allowing heat from the refrigerator to dissipate.
* If there is concern of noise, wall fouling or discoloration, or condensation
on the back of the refrigerator or wall when humidity is high, leave space
between the back of the refrigerator and the wall.
Installation
1
Use in hot spring or geothermal areas
Corrosion control treatment may be required
for the refrigerant circuit (pipe) due to
generation of corrosive gases.
Contact the retail store where you purchased
the refrigerator.
From Installation to Operation
Do not install the refrigerator outdoors or in a
place exposed to water or excessive humidity.
Water may cause insulation failure, resulting in electric
shock or fire.
Water
prohibited
Space of 0.5 cm
or more
Space of 5 cm or more
Connect the Power Supply
* Connect power supply soon after installing
the refrigerator
2
Use a dedicated outlet
Use a dedicated outlet for the power supply that meets
the rating specified on the rating label. (The rating label is
located on the door-liner of the refrigerator compartment.)
Using outlets that do not meet the specified rating or
plugging in too many leads into a single socket can
cause heat buildup or fire.
The refrigerator will not be damaged even if the
power is supplied soon after installation.
It takes a while for the refrigerator to cool,
therefore supply power as soon as possible.
Electrical Connections
Make sure this unit is properly grounded.
●
The refrigerator should always be plugged into its
dedicated electrical outlet.
This will provide the best performance and prevent
electrical circuits from being overloaded and causing a fire.
Make sure that the electrical outlet provides the proper
voltage.
Extension cords are not recommended.
● If your refrigerator is installed in the high humidity
location, not only ground connection but also installation
of the earth leakage breaker is recommended.
● If the power cord is damaged, purchase a new cord
from MITSUBISHI ELECTRIC SERVICE CENTER
or its service agent. Make sure that the power cord is
designed for this model, in order to avoid a hazard.
● If the power cord is damaged, contact MITSUBISHI
ELECTRIC SERVICE CENTER or its service agent
for the replacement, in order to avoid a hazard.
9 8