63
OPERATING PROCEDURE
PHOTOS
1. Removing the cabinet and electrical parts
(1) Remove the top panel (3 screws in front, 2 screws in rear)
(2) Remove the cover panel (1 screw).
The panel is anchored by clicks to the side panel.
Remove by pulling towards you.
(3) Remove the cover panel (1 screw).
The panel is anchored by clicks on the right and left sides.
After removing the screw, pull the panel down and remove it
by pulling towards you.
2. Removing the outdoor fan motor
(1) Remove the front panel (3 screws).
Open the panel to a 45 degree angle and lift to remove. The
panel is clasped at three points on the left side.
(2) Remove the propeller fan (1 set nut).
(3) Remove the fan motor (3 screws).
Remove the lead connectors.
12-5 MUH17NN
OUTDOOR UNIT
Photo 1
Outdoor
controller
board
Transformer Capacitor
Contactor
Terminal block
Screws
Photo 2
Propeller fan
Motor support
Separator support plate
High-pressure switch
Lead
connectors
Valve bed
Crankcase heater
Propeller nut
Photo 3
Screws
Top panel
Service
panel
Cover
panel
Front panel
OB198--2.qxp 24/6/97 6:06 AM Page 63
Содержание Mr. Slim MSH09NW
Страница 2: ......
Страница 72: ...72 1 3 8 11 4 2 13 14 6 7 9 10 17 19 20 15 16 5 OUTDOOR UNIT STRUCTURAL PARTS MUH17NN 18 21 ...
Страница 75: ......