En-6
Remote controller
Remote controller
holder
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are)
heard from the in-
door unit when the
signal is received.
Operation
display section
OFF/ON
(stop/ operate)
button
Temperature buttons
Page 7
Operation
select button
Page 7
ECONO COOL
button
Page 9
FAN speed
control button
Page 8
Off-timer button
Page 10
On-timer button
Page 10
VANE control
button
Page 8
TIME set buttons
Pages 6, 10
Increase time
Decrease time
CLOCK button
Page 6
RESET button
Page 6
Lid
Slide down
to open
• Install the remote
controller holder
in a place where
the signal can be
received by the
indoor unit.
Only use the remote controller provided with the unit.
Do not use other remote controllers.
If two or more indoor units are installed in proximity to
one another, an indoor unit that is not intended to be
operated may respond to the remote controller.
POWERFUL COOL
button
Page 10
N
AME OF EACH PART
Before operation:
Insert the power supply plug into the
power outlet and/or turn the breaker on.
P
REPARATION BEFORE OPERATION
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries.
The remote controller could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However,
batteries with expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller
may not operate correctly.
•
Press CLOCK gently using a thin
instrument.
Installing the remote controller batteries
Setting current time
1.
Press CLOCK.
3.
Press CLOCK
again.
2.
Press the TIME buttons
to set the time.
Each press increases/
decreases the time by
1 minute (10 minutes
when pressed longer).
1.
Remove the front lid.
3.
Install the front lid.
4.
Press RESET.
2.
Insert the negative
pole of AAA alkaline
batteries first.
