22
Maintenance
Remove the power plug before you begin maintenance.
Do not use detergents, cleaning agents for heat exchange equipment, abrasive
powders, chemically treated dusters, gasoline, benzene, thinners or other solvents,
as they can damage the unit or the water tank, which may result in leakage.
Cleaning
Water tank · Main unit
Wipe with a soft cloth.
Floating element
Do not remove or dismantle.
The unit draws in dust present in the air, and this
may cause the tank to
gradually become dirty
. If
the dirt does not come off easily, wash with cold
or warm water, then wipe with a soft, dry cloth.
Mildew may form in the tank unless kept clean.
After cleaning the tank, attach the tank guard and
then set the tank in the unit.
Once Every Two Weeks
Pre-fi lter and sensor part
Clogging with dust and the like reduces the
effectiveness of dehumidifying. Clean about once
every two weeks.
How to remove and attach
P10
1
Remove the pre-fi lter.
2
Remove the silver ion fi lter.
3
Clean the pre-fi lter.
Use a vacuum cleaner
to suck up any dirt.
When the fi lter is very dirty, wash it
in lukewarm water and dry it well.
4
Clean the
sensor part.
Use a vacuum cleaner
to suck up any dirt.
5
Set the silver ion fi lter.
Make sure the silver ion fi lter is attached to
the unit. If it is not, fi ne dust will enter inside
the unit and cause a malfunction.
6
Set the pre-fi lter.
Once Every Three Months
Silver Ion Filter
Soak the silver ion fi lter in water.
How to remove and attach
P10
1
Remove the pre-fi lter.
2
Remove the silver ion fi lter.
3
Soak the silver ion fi lter in
water.
Soak in cool to
lukewarm water for
about 30 minutes.
Do not use detergent or hot water. Also, do
not use a brush or the like to scrub the fi lter
or rub the fi lter while soaking. This may
damage the fi lter.
Any yellow or dark stains may remain on the
fi lter, but should not affect performance.
The fi lter can be soaked for a total of eight
times. After that, replace with a new fi lter.
4
Dry the silver ion fi lter well.
Dry the fi lter on a even
surface in the shade.
Do not hang with pegs or the like. This may
damage the fi lter.
Do not use the fi lter while wet.
5
Set the silver ion fi lter.
6
Set the pre-fi lter.
e̲mj̲e26cx̲h.indb 22
e̲mj̲e26cx̲h.indb 22
2009/10/26 17:22:25
2009/10/26 17:22:25
