Test run
1
2
3
4
5
6
7
8
Do not turn the power switch on with your hands inside the Hand-drying area.
Turn the power switch off if the check lamp in the display is either on or blinking, and then turn the power back on 40 seconds
after you’ve made sure all the lamps in the display are off.
*
*
Check power supply voltage
Is single-phase alternating current 120V being used?
Turn the ground-fault circuit interrupter on
Turn the power switch on
Turn on power by using the means for
disconnection
Is the power lamp in the display on ?
Dry hands
Is the air blowing?
Turn the air speed knob while inserting the
hands.
Turn on the heater switch.
Does the air speed change?
Is the heater lamp illuminating at the display?
Does hot air blow out? (It takes a few minutes before hot air
blows after turning on the switch.)
(Burning smell of oil, dirt, etc. at the heat storage section in
the heater may be felt at the start of use but this is normal
and there is no problem.)
Step
What to check for
Check
Is the unit mounted securely without any vibration or noises?
7
JT-SB116EH-W-CA-IM_874HD7001-GB 06.12.9 2:13 PM ページ 4
