The Instruction Manual and Usage Sticker are for the customer, and should be handed over together with the unit.
Read this manual thoroughly before beginning installation to ensure the unit is installed safely and correctly.
Local installation standards should be obeyed and installation should be performed by a qualified professional.
Installation Manual
Hand Dryer
Model
JT-SB116EH-W-CA
Single-phase 120VAC
0612874HD7001
GB
For dealers and installers
Do not disassemble
Do not use in shower room
Use a single-phase alternating current 120V power supply.
Voltage in excess of 120V+10% may cause mechanical failure, so stay within the rated range.
Using an incorrect power supply may cause fire, electric shock, or malfunction.
Electrical wiring work should be done by a certified professional in conformance with local standards.
Incorrect wiring can cause electric shocks and fire.
Be sure to install a ground-fault circuit interrupter.
Lack of one may cause electric shock.
A means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
This appliance is not intended for use by young children or infirm persons unless they are adequately
supervised by a responsible person to ensure that they can use the appliance safely.
Young children should be supervised to ensure that they do not play with the appliance.
Do not modify or disassemble more than necessary.
This may cause fire, electric shock, or injury.
Do not install in shower room or other locations with a great deal of humidity in the air, where
condensation may form on the unit, or where the unit may come in direct contact with water.
This may cause electric shock or malfunction.
Important!
Follow instructions
Safety precautions
Grounded connection
Be sure the unit is properly grounded.
Lack of a proper ground may cause electric shock during malfunction or short circuit.
WARNING
The following may lead to death or serious
personal injury if done incorrectly.
CAUTION
The following may lead to injury or damage to
buildings or their contents if done incorrectly
Do not attempt installation with the power on in the unit (supply mains).
This may cause electrical shock.
Do not remove the heater.
It may cause fire, electric shock or injury.
Do not use at locations where salt damage may occur or where corrosive, neutral or reductive gas
are present.
Failure to do any of the above may cause fire, electric shock or trouble.
Prohibited
Do not install the unit in places where vandalism might occur.
Vandalism may cause malfunction.
Install in a location strong enough to support the weight of the unit.
Injury may be cause by the unit falling.
Wear gloves when installing the unit.
Not doing so may cause injury.
Important!
Follow instructions
JT-SB116EH-W-CA-IM_874HD7001-GB 06.12.9 2:13 PM ページ 2
