Mitsubishi Electric FR-E700EX, Инструкция по эксплуатации

Страница: 79 / 323

77
4
P
ARAME
TERS
PM sensorless vector control
(3) Valid/invalid statuses of monitor outputs during the test operation

: Valid

: Invalid (always displays 0)

: Displays accumulated value before the test
—
: Not monitored

Monitor output is valid or invalid depending on the monitor type (operation panel display, parameter unit display, or terminal FM/ AM). For details,
refer to page 155.

When the operation is switched to the test operation, "0" is displayed. When PM sensorless vector control is selected again after a test operation, the
output current peak value and the electronic thermal relay load factor from the last operation are displayed.
Monitoring items
DU/PU monitor
display
FM
output
Communication
Rotation speed   
Output current
  
Output voltage
  
Fault display  — 
Speed setting value   
Converter output voltage   
Regenerative brake duty   
Electronic thermal relay load factor






Output current peak value






Converter output voltage peak value   
Output power
  
Position pulse
  
Cumulative energization time  — 
Reference voltage output —  —
Actual operation time  — 
Motor load factor
  
Cumulative power

—

Position command (upper/lower)
  
Current position (upper/lower)
  
Droop pulse (upper/lower)
  
Ideal speed command
  
Speed command   
PID set point   
PID measured value   
PID deviation  — 
Input terminal status —/  — 
Output terminal status —/  — 
Drive unit I/O terminal status  /— — —
Motor thermal relay load factor






Drive unit thermal relay load factor






Cumulative power
(for communication, in units of 0.01 kWh)
— —

Parameters referred to
Pr.52 DU/PU main display data selection Refer to page 155
Pr.178 to Pr.184 (input terminal function selection) Refer to page 138
Pr.190 to Pr.192 (output terminal function selection) Refer to page 144