Mitsubishi Electric CITY MULTI PVFY-P12NAMU-E, Техническое и сервисное руководство

Страница: 36 / 44

[
VIII
Troubleshooting ]
- 29 -
HWE1405A GB
5. Dipswitch setting (Factory setting)
1. Function setting
(1) SW1
1) Adress board
(2) SW3
1) Indoor control board
Dipswitch settings must be made while the unit is stopped.
Switch position Function Switch setting
ON OFF
1 Active Thermistor (Intake air
thermistor)
Built-in thermistor on the remote
controller
Indoor unit
2 Filter clogging detection Available Unavailable
3 Filter life 2500 hr 100 hr
4 Outdoor air intake Enabled Disabled
5 Remote display Thermo-ON signal Fan output
6 Humidifier operation During heating mode During heating operation
7 Fan speed Low Very low
8 Fan speed at heating Thermo-OFF Preset fan speed Follows the setting of SW1-7
9 Auto restart after power failure Enabled Disabled
10 Power start/stop Enabled Disabled
Factory setting
Switch position Function Switch setting
ON OFF
1 Unit type Cooling only Heat pump
2 Heater thermo type Type #2 (economy mode) Type #1 (comfort mode)
3 - - -
4 Heater control Enabled heater comfort and
economy modes
*1
Enabled heater basic control
5 - - -
6 - - -
7 - - -
8 Heating 4-deg up Disabled Enabled
9 - - -
10 - - -
*1. While the heater is on, the fan will operate at high speed regardless of the fan setting on the remote controller.
Factory setting