12
7HVWUXQ
8VLQJUHPRWHFRQWUROOHU
Refer to the indoor unit installation manual.
%HVXUHWRSHUIRUPWKHWHVWUXQIRUHDFKLQGRRUXQLW0DNHVXUHHDFKLQGRRU
unit operates properly following the installation manual attached to the unit.
,I\RXSHUIRUPWKHWHVWUXQIRUDOOLQGRRUXQLWVDWRQFH\RXFDQQRWGHWHFWDQ\
erroneous connection, if any, of the refrigerant pipes and the connecting
wires.
* The compressor operation is not available for 3 minutes at least after the
power is supplied.
7KHFRPSUHVVRUFDQHPLWQRLVHMXVWDIWHUWXUQRQWKHSRZHUVXSSO\RULQFDVH
of low outside air temperature.
$ERXWWKHUHVWDUWSURWHFWLYHPHFKDQLVP
Once the compressor stops, the restart preventive device operates so the compressor
will not operate for 3 minutes to protect the air conditioner.
8VLQJ6:LQRXWGRRUXQLW
Note:
,QFDVHRIWKHWHVWUXQIURPRXWGRRUXQLWDOOLQGRRUXQLWVRSHUDWH7KHUHIRUH
\RX FDQ QRW GHWHFW DQ\ HUURQHRXV FRQQHFWLRQ RI UHIULJHUDQW SLSHV DQG WKH
FRQQHFWLQJZLUHV,ILWDLPVDWGHWHFWLRQRIDQ\HUURQHRXVFRQQHFWLRQEHVXUH
WRFDUU\RXWWKHWHVWUXQIURPUHPRWHFRQWUROOHUZLWKUHIHUHQFHWR³8VLQJ
UHPRWHFRQWUROOHU´
SW3-1
21
Cooling operation
SW3-2
OFF
SW3-1
21
Heating operation
SW3-2
21
* After performing the test run, set SW3-1 to OFF.
$IHZVHFRQGVDIWHUWKHFRPSUHVVRUVWDUWVDFODQJLQJQRLVHPD\EHKHDUGIURP
the inside of the outdoor unit. The noise is coming from the check valve due to the
small difference in pressure in the pipes. The unit is not faulty.
7KHWHVWUXQRSHUDWLRQPRGHFDQQRWEHFKDQJHGE\',3VZLWFK6:GXULQJ
WKHWHVWUXQ7RFKDQJHWKHWHVWUXQRSHUDWLRQPRGHGXULQJWKHWHVWUXQVWRS
WKHWHVWUXQE\',3VZLWFK6:$IWHUFKDQJLQJWKHWHVWUXQRSHUDWLRQPRGH
UHVXPHWKHWHVWUXQE\VZLWFK6:
7HVWUXQ
%HIRUHWHVWUXQ
Ź
$IWHUFRPSOHWLQJLQVWDOODWLRQDQGWKHZLULQJDQGSLSLQJRIWKHLQGRRUDQG
RXWGRRUXQLWVFKHFNIRUUHIULJHUDQWOHDNDJHORRVHQHVVLQWKHSRZHUVXSSO\
RUFRQWUROZLULQJZURQJSRODULW\DQGQRGLVFRQQHFWLRQRIRQHSKDVHLQWKH
VXSSO\
Ź
8VHDYROW0RKPWHVWHUWRFKHFNWKDWWKHUHVLVWDQFHEHWZHHQWKHSRZHU
VXSSO\WHUPLQDOVDQGJURXQGLVDWOHDVW0
:
.
Ź
'RQRWFDUU\RXWWKLVWHVWRQWKHFRQWUROZLULQJORZYROWDJHFLUFXLWWHUPL
-
nals.
:DUQLQJ
'RQRWXVHWKHDLUFRQGLWLRQHULIWKHLQVXODWLRQUHVLVWDQFHLVOHVVWKDQ0
:
.
,QVXODWLRQUHVLVWDQFH
After installation or after the power source to the unit has been cut for an extended
period, the insulation resistance will drop below 1 M
:
due to refrigerant accumulating
in the compressor. This is not a malfunction. Perform the following procedures.
1. Remove the wires from the compressor and measure the insulation resistance of
the compressor.
2. If the insulation resistance is below 1 M
:
, the compressor is faulty or the resist-
ance dropped due the accumulation of refrigerant in the compressor.
3. After connecting the wires to the compressor, the compressor will start to warm
up after power is supplied. After supplying power for the times indicated below,
measure the insulation resistance again.
7KHLQVXODWLRQUHVLVWDQFHGURSVGXHWRDFFXPXODWLRQRIUHIULJHUDQWLQWKHFRP
-
pressor. The resistance will rise above 1 M
:
after the compressor is warmed
up for four hours.
(The time necessary to warm up the compressor varies according to atmospheric
conditions and refrigerant accumulation.)
7RRSHUDWHWKHFRPSUHVVRUZLWKUHIULJHUDQWDFFXPXODWHGLQWKHFRPSUHVVRUWKH
compressor must be warmed up at least 12 hours to prevent breakdown.
4. If the insulation resistance rises above 1 M
:
, the compressor is not faulty.
Caution:
7KHFRPSUHVVRUZLOOQRWRSHUDWHXQOHVVWKHSRZHUVXSSO\SKDVHFRQQHFWLRQ
is correct.
7XUQRQWKHSRZHUDWOHDVWKRXUVEHIRUHVWDUWLQJRSHUDWLRQ
- Starting operation immediately after turning on the main power switch can result
in severe damage to internal parts. Keep the power switch turned on during the
operational season.
Ź
7KHIROORZLQJVPXVWEHFKHFNHGDVZHOO
7KHRXWGRRUXQLWLVQRWIDXOW\/('RQWKHFRQWUROERDUGRIWKHRXWGRRUXQLWÀDVK
when the outdoor unit is faulty.
%RWKWKHJDVDQGOLTXLGVWRSYDOYHVDUHFRPSOHWHO\RSHQ
5HIULJHUDQWFROOHFWLQJ3XPSGRZQ
Perform the following procedures to collect the refrigerant when moving the indoor
unit or the outdoor unit.
1
Turn off the circuit breaker.
2
Connect the low pressure side of the gauge manifold to the service port of the
gas side stop valve.
3
Close the liquid stop valve.
4
Supply power (circuit breaker).
* Start-up of the indoor-outdoor communication takes about 3 minutes after the
power (circuit breaker) is turned on. Start the pump-down operation 3 to 4 minutes
DIWHUWKHSRZHUFLUFXLWEUHDNHULVWXUQHG21
5
&RQ¿UPWKDW6:LVVHWWR2))DQGWKHQVHW6:WR21WRSHUIRUPWKHWHVW
run for cooling operation. The compressor (outdoor unit) and ventilators (indoor
and outdoor units) start operating and test run for cooling operation begins.
Immediately after performing the test run for cooling operation, set the outdoor
VHUYLFHVZLWFK6:SXPSGRZQVZLWFKIURP2))WR21
'RQRWFRQWLQXHWRRSHUDWHIRUDORQJWLPHZLWKWKHVZLWFK6:VHWWR210DNH
sure to switch it to OFF after pump down is completed.
6
Fully close the gas stop valve when the pressure reading on the gauge drops
03DDSSUR[LPDWHO\NJIFP
2
)
7
Set SW3-1 to OFF to stop the air conditioner operation. (Set the outdoor service
VZLWFK6:IURP21WR2))
8
Turn off the power supply (circuit breaker).
* If too much refrigerant has been added to the air conditioner system, the pressure
PD\QRWGURSWRNJIFP
2
. If this occurs, use a refrigerant collecting device
to collect all of the refrigerant in the system, and then recharge the system with
the correct amount of refrigerant after the indoor and outdoor units have been
relocated.
:DUQLQJ
:KHQSXPSLQJGRZQWKHUHIULJHUDQWVWRSWKHFRPSUHVVRUEHIRUHGLVFRQQHFW
-
LQJWKHUHIULJHUDQWSLSHV7KHFRPSUHVVRUPD\EXUVWDQGFDXVHLQMXU\LIDQ\
IRUHLJQVXEVWDQFHVXFKDVDLUHQWHUVWKHV\VWHP
Содержание CITY MULTI PUMY-P NHMU
Страница 35: ......
