Mitsubishi Electric CAHV-P500YB-HPB, Руководство по обслуживанию

Страница: 85 / 169

[
VII
Control ]
- 78 -
HWE15070 GB
(5) Setting the total number of units for a multiple system
Setting the unit addresses
Refer to
"System configuration procedures: Multiple system" (page 22)
.
Step 0
Set the ON/OFF
switch (SWS1) to
OFF.
Set SWS1 to OFF from the remote controller or with the local switch.
Settings cannot be changed unless the ON/OFF switch is set to OFF.
Step 1
Set the dip switches
SW2 and SW3.
Set the dip switches on the circuit board as follows to select how external inputs are received.
Step 2
Select the desired
item with the push
switch SWP3.
The item codes shown in the table below will appear in order every time the push switch
SWP3 is pressed.
Use the push switches SWP1 and SWP2 to change the value of the selected item.
The value will keep blinking while it is being changed.
Step 3
Press the push
switches SWP1 (↑)
or SWP2 (↓) to
increase or
decrease the value.
Step 4
Press the push
switch SWP3 to
save the change.
Press SWP3 once within one minute of changing the setting with SWP1 or SWP2 to save the
setting.
Once the new setting is saved, the display will stop blinking and stay lit. The display will, then,
return to the item code display mode.
If SWP3 is not pressed within one minute, the change will not be saved and the display will
return to the item code display mode.
Step 5
Turn the power back
on.
Reset the system.
After changing the settings, re-initialize the system according to the procedures detailed on
page 24.
SW2 SW3
-10 5 6 7 8 9 10
OFF OFF OFF OFF ON ON ON
Setting thetotal number of units
*1 Enter the total number of units including the main unit. Applicable only to the main unit.
Item code Increments Lower limit Upper limit Initial value
Total number of units in the system*1 107 1 1 16 1
Note The new setting will not be saved unless a reset is performed.
0000001906.book 78 ページ ２０１５年１１月５日 木曜日 午前１１時５５分